AFG 1.0AT User's Guide download pdf (Page 9)

INTRODUCTION

IMPORTANT

PRECAUTIONS

ASSEMBLY

BEFORE

YOU BEGIN

TREADMILL

OPERATION

CONDITIONING

GUIDELINES

TROUBLESHOOTING

& MAINTENANCE

LIMITED

WARRANTY

ASSEMBLY STEP 2

RIGHT CONSOLE MAST

BOLT (D)

PRE-ATTACHED BOLT

RIGHT LINKAGE ARM

ELEVATION FRAME

CONSOLE CABLE

FLAT WASHER (E)

WAVY WASHER (F)

MAIN FRAME

BOLT (D)

Qty: 1

FLAT WASHER (E)

27 mm

Qty: 1

WAVY WASHER (F)

29 mm

Qty: 1

HARDWARE BAG 2 CONTENTS :

Pull LEAD WIRE through RIGHT CONSOLE MAST. After

pulling the LEAD WIRE through the mast, the top of the

CONSOLE CABLE

should be located at the top of the

mast. Detach and discard LEAD WIRE.

Open HARDWARE BAG 2.

Move RIGHT LINKAGE ARM into position and attach to

ELEVATION FRAME.

NOTE

: While holding RIGHT CONSOLE MAST in the

upright position, tighten PRE-ATTACHED BOLT using

T-wrench to attach RIGHT LINKAGE ARM.

Insert 1 BOLT (D) and 1 FLAT WASHER (E) through

RIGHT CONSOLE MAST

followed by 1 WAVY WASHER (F)

and attach to MAIN FRAME.

Lift the RUNNING DECK until lock latch on side of

treadmill is fully engaged.

Remove CONSOLE from box and place out of the way.

Lower the treadmill RUNNING DECK from the folded

position by stepping on LOCK LATCH on lower right side.

NOTE: If you have attempted to

move the treadmill from the box

and the machine has sprung

open and cannot be assembled,

refer to the troubleshooting

section in order to restore the

treadmill to its proper position.

RIGHT CONSOLE MAST

CONSOLE CABLE

LEAD WIRE

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Comments to this Manuals

No comments

AFG 1.0AT User's Guide Page 9

Comments to this Manuals

Related products and manuals for Treadmills AFG 1.0AT