AFG 13.0 AT User's Guide download pdf (Page 8)

ii¸ _/

13.0AT Rev.l.7.indd 14-15

TENSIONINGTIlERUNNINGBELT

The running belt has been properly adjusted at the

factory before it was shipped. At times the belt can

move off-center during shipment,

CAUTION:Running belt should NOT be moving during

tensbning. Over-tightening the running belt can

cause excessive wear on the treadmifl as weft as its

components, Never over-tighten the belt,

If you can feel a slipping sensation when running on the

treadmill, the runnfi7g belt must be tightened, In most

cases, the belt has stretched from use, causing the

belt to slip. This is a normal and common adjustment,

To eliminate this slipping, TURN THE TREADMILLOFF

and tension BOTH THEREARROLLERBOLTSusing the

supplied Allen wrench, turning them 1/4 TURNto the

right as shown. Turn the treadmill on and check for

slipping. Repeat if necessary, but NEVER TURN the

roller bolts more than 1/4 turn at a time. Belt is properly

tensioned when the slipping sensation is gone,

Belt istoo far to the right side

Beltis too far to the left side

CENTERINGTIlERUNNINGBELT

Therunning belt has been properly adjusted at the

factory before it was shipped. At times the belt can

move off-center during shipment. Before operating the

treadmill, make sure the belt is centered and remains

centered to maintain smooth operation,

CAUTION:Do not run belt faster than 1/2 rnph while

centering, Keep fingers, hair and clothing away from

belt at all times,

If the runningtier is too far to the right side:

With the treadmill running at 1/2 mph, turn the right

adjustment bolt clockwise 1/4 TURNat a time (using

the supplied Aden wrench). Check the belt alignment.

Allow belt to run a furl cycle to gauge if more adjustment

is needed, Repeat if necessary, until the belt remains

centered during use,

If the running belt is too far to the left side:

With the treadmill running at 1/2 mph, turn the right

adjustment bolt counter-clockwise 1/4 TURNat a time

(using the supplied Allen wrench). Check the belt

alignment, Allow belt to run a furl cycle to gauge if more

adjustment is needed, Repeat if necessary, until the

belt remains centered during use,

& CAUTION_

aa:aa ::::::::::::::[aa.aaj

_)XEAR:RA:E _ (_CALORIES

®..........®

l _,WARNING_

Note: Thereis a thin protective sheet of clear plastic on the overlay of the console and should be removed,

A) WORKOUTPROFILEDISPLAK.Displaysworkoutprofiles.

B) ADDITIONALDISPLAYWINDOWS:Time,Incline,Distance,Speed,HeartRateand Cabries.

C) CLOCK/DATEWINDOW:Displayseither Clockor Date.

D) START..Simplypress to beginexercisingorstarts your workout.

E) STOP:Presstopause/endyour workout.Holdfor 3 secondsto resetthe treadmill.

F) PROGRAMMINGBUTTON:Usedto select Program,Leveland Time,and other options. Pressto changedisplay feedback

during workout.

G) INCLINEARROWKEY$:Pressto adjust incline (+/- 0.57/ooincrements).

H) SPEEDARROWKEYS:Pressto adjust speed (+/- O.1MPHincrements).

I) PROFILErM BUTTON:Usedto scrodthroughproFILE:M displaymodes.

l) QUICKADIUSTKEYPAD:Usedto reachdesiredspeedor incline morequickly.

K) AUDIOIN (NOTSHOWN):Plugyour CD/ MP3playerinto the consoleusin_ the included audioadaptor cable.

L) AUDIOOUT/ HEADPHONEIACK(NOTSHOWN):Plugyour headphonesinto this jack to listen toyour music through the

headphones.

4/1/08 3:41:09 PM

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 18 19

Comments to this Manuals

No comments

AFG 13.0 AT User's Guide Page 8

Comments to this Manuals

Related products and manuals for Treadmills AFG 13.0 AT