AFG 2.0AT User's Guide download pdf (Page 15)

BEFORE

YOU BEGIN

ASSEMBLYASSEMBLY

INTRODUCTION

IMPORTANT

PRECAUTIONS

TREADMILL

OPERATION

CONDITIONING

GUIDELINES

TROUBLESHOOTING

& MAINTENANCE

LIMITED

WARRANTY

ASSEMBLY

BEFORE

YOU BEGIN

IMPORTANT

PRECAUTIONS

PROPER USAGE

Your treadmill is capable of reaching high speeds. Always start off using a slower speed and adjust the speed in

small increments to reach a higher speed level. Never leave the treadmill unattended while it is running. When

not in use, remove the safety key and keep out of reach of children, turn the on/off switch to off and unplug the

power cord. Make sure to follow the MAINTENANCE schedule located on page 33 in this manual. Keep your body

and head facing forward. Do not attempt to turn around or look backwards while the treadmill is running. Stop

your workout immediately if you feel pain, faint, dizzy or are short of breath.

Do not operate the treadmill if the power cord or plug is damaged.

If the treadmill appears to not be working properly, do not use the treadmill.

FOLDING

Firmly grasp the back end of the treadmill. Carefully lift the end of the

treadmill deck into the upright position until the foot lock latch engages

and securely locks the deck into position. Make sure the deck is securely

latched before letting go. To unfold, firmly grasp the back end of the

treadmill. Gently press down on the foot lock latch with your foot until the

lock latch disengages. Carefully lower the deck to the ground.

MOVING

Your treadmill has transport wheels built into the frame. To move,

make sure the treadmill is folded and securely latched. To unlock

wheels, push down on the top lever of the rear wheel locks located on

the rear corners of the base frame. Then firmly grasp the handlebars,

and slowly move the treadmill. After moving to the desired location,

push down on the bottom lever of the rear wheel locks to lock the

rear wheels.

NOTE: Both rear wheel locks MUST be locked before using the

treadmill.

Our treadmills are heavy, use care and additional help if necessary when moving.

Do not attempt to move or transport treadmill unless it is in the upright, folded

position with the lock latch secured. Do not attempt to disassemble machine and

transport. Failure to follow these instructions could result in injury.

POWER

The power cord must be plugged into the power jack, which is located in the front of the machine below the

MOTOR COVER. Make sure the power switch is in the ON position. After use, the power switch should be turned

to the OFF position.

WARNING

WHEEL LOCKS

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Comments to this Manuals

No comments

AFG 2.0AT User's Guide Page 15

Comments to this Manuals

Related products and manuals for Treadmills AFG 2.0AT